Premium Based Alloys

PREMIUM BASED ALLOYS

Premium Based Alloys are a special blend of Tungsten Carbide Particles and a High content Matrix to form a Heavy Wear, Hardsurfacing Material designed to withstand the heaviest wear applications. Such applications include, Oil Drilling where there is the presence of hard rock formations. Milling Tools that have the presence of alloy based materials lost downhole, and extreme wear conditions of snow removal equipment such as Commercial Airports and Government Landing Strips.

Premium Based Alloys are not designed to withstand high impact, although it's chemical analysis will withstand all high wear conditions and most chemical compounds.

All Premium Based Alloys are to be applied with Oxygen and Acetylene Torches and it is preferred that the apparent material be preheated to 600 degrees Fahrenheit. Torch and Rod material should be held at a 45 degree angle opposite of each other and maintain and steady and consistent flow of material.

TRICONI - SIZES , ROCKWELL HARDNESS AND APPLICATIONS

Triconi: TC-610, TC-34A, TC-44A, TC-54A, TC-54AB consist of a crushed, and rolled Tungsten Carbide Grit in forms of Sintered, Cast, Pellet, and Tritung.

Triconi Rockwell Hardness Application

TC-610
ALL MESH SIZES
UP TO 40 THIS APPLICATION IS USED WHERE THERE IS A MEDIUM IMPACT AND SEVERE WEAR IS NOT A FACTOR

TC-34A
ALL MESH SIZES
UP TO 45 THIS APPLICATION IS USED WHERE THERE IS A MEDIUM IMPACT AND SEVERE WEAR IS A FACTOR

TC-44A
ALL MESH SIZES
UP TO 55 THIS APPLICATION IS USED WHERE THERE IS A LIGHT IMPACT AND EXTREME WEAR IS A COMMON FACTOR

TC-54
TC-54AB
55 PLUS THIS APPLICATION IS USED WHERE THERE IS A LIGHT IMPACT AND EXTREME WEAR IS A MAIN FACTOR

OVERLAY
N/A THIS MATERIAL IS USED TO TOUCH UP APPLICATIONS WHERE MINIMAL BUILD-UP IS REQUIRED

UNDERLAY
N/A THIS MATERIAL IS USED FOR
PRE-TINING PREPARATION
BEFORE APPLY MATERIAL